+8615906071097
Cement Curb Molds
video
Cement Curb Molds

Cement Curb Molds

This innovative tool allows merchants to create precise and professional-looking concrete curbs with ease. 1.Hardness for inserts:HRC61-65
2.Hardness for shoes:HRC59-62
3.Carburized layer thickness:1.3-1.5mm
4.Unilateral clearance between presser foot and mold cavity: 0.2 mm ≤ Unilateral clearance ≤ 0.4mm
5.Flatness of the whole board: ≤ 0.5mm
Send Inquiry
Product Details ofCement Curb Molds

Curb Molds Concrete

What Sets Cement Curb Molds Apart

Unlike general concrete molds, cement curb molds face unique demands. The product is long and narrow-typically 500mm to 1000mm in length-with a height-to-width ratio that makes consistent demolding challenging. Uneven ejection pressure can crack a green curb or distort its profile.

UNIK curb molds address these challenges through targeted engineering choices.

Reinforced cavity walls – Additional thickness at stress points prevents deformation under production vibration.

Controlled draft angles – Precision-angled cavity walls allow smooth block release without binding.

Wear-resistant edges – The cavity perimeter receives additional hardening to resist abrasion from concrete aggregates during repeated cycles.

Material Science and Heat Treatment

The service life of a cement curb mold depends primarily on two factors: steel selection and heat treatment depth.

Steel grade

UNIK fabricates curb molds from low-carbon alloy steel selected for carburizing capability. The base material remains tough and impact-resistant, while the surface can be hardened to resist abrasion. Chrome plating is applied as a standard finish, creating a smooth cavity surface that blocks rust formation and extends service life beyond 600,000 cycles.

Carburizing depth

The carburized layer reaches 1.3mm to 1.6mm beneath the cavity surface. This depth ensures that the wear-resistant zone remains intact even after hundreds of thousands of cycles. Post-carburizing vacuum quenching and tempering transform the case structure to fine-grained martensite, producing surface hardness of HRC59-62.

Core toughness

While the surface hardens, the steel core maintains lower hardness to absorb production vibration. This differential heat treatment-hard surface, tough core-prevents the brittle cracking that affects fully hardened molds.

  •  

 

 

Dimensional Control and Precision

Cement curbs must align perfectly when installed end-to-end. A deviation of 2mm in length, height, or width creates gaps, misaligned joints, and water infiltration paths.

UNIK holds curb mold dimensions to the following tolerances:

Parameter Tolerance
Single cavity dimensions -0.3mm to +0.3mm
Filling depth (height) ±0.5mm
Unilateral clearance (presser foot to cavity) 0.2mm to 0.4mm
Whole board flatness ≤0.5mm

These tolerances are achieved through CNC gantry machining and wire-cutting processes. The tight unilateral clearance-the gap between the presser foot and cavity wall-prevents concrete leakage upward while allowing the presser foot to move freely.

QQ20250823-133400
 

Hot Tags: cement curb molds, China cement curb molds manufacturers, suppliers, factory, Concrete Curb Mould, curb moulds, Curb Stone Mould, Kerb Stone Mould, Road Curb Moulds

Send Inquiry

(0/10)

clearall